Owners manual

WARN® INDUSTRIES PAGE 12 83138A1
Installation continued
19. Install T-handle retaining cord.
This elastic cord is intended to hold the T-handle
near the eye-bolt used to hold handle.
Loop the cord around a tube or object in “chocker”
style, Figure 18. Insert the pull cord and the
barbed end of the elastic cord into the pull handle.
Tie the pull cord to the retaining bar. Figure 19.
Re-install or adjust length by coiling so there is
only light cord tension.
20. Install the rope and T-handle in the eye-bolt (Fig-
ure 20) after the holder has been secured to the
left rack tube.
21. Tie the Rope Release Rope to the Latch (Figure
21).
Make sure the vehicle and bucket are on at level
surface before securing rope. There should be
very little or no slack in the release rope when in-
stalling it. This rope will stretch the rst few times
it is used.
The rope will be slack when the bucket is in the
raised position.
Trim excess rope after installation is complete.
Figure 18
Figure 19
Figure 20