Owners manual

WARN® INDUSTRIES PAGE 11 83138A1
Installation continued
15. Install bucket on vehicle. Slide bucket to the vehi-
cle or have second person help carry it to vehicle.
Attach bucket to plow mount. Secure bucket to
mount with pins Make sure pins are secure to
mount and will not come out.
16. Route the winch rope through the pulley assembly
on plow (Figure 15).
NOTE: A roller fairlead is required for this application.
The use of a plow roller fairlead (large roller)
and a short synthetic rope is highly recom-
mended.
17. Install the termination strap on the front rack (g-
ure 16). Position this strap so that it is contacting
the rack as close to the frame mounting points as
possible.
Wrap the strap around the rack and front bumper
as needed to position the end of winch rope in an
area that will not damage the front of vehicle.
NOTE: The strap must be wrapped around the largest
diameter tube available, this will improve life of
strap.
Make sure rope hook or termination link is lo-
cated as far as possible from pulley on bucket.
18. The latch release pull handle will be secured to
the front rack with 5/16” eye bolt and rack clamps,
as shown in Figure 17.
The end of the eye bolt may need to be trimmed
to clear the body plastic under the rack.
Install the eye bolt directly to the front rack if the
vehicle is equipped with composite racks. This
will require drilling.
Figure 17
Figure 16
Figure 15