Owners manual

WARN® INDUSTRIES PAGE 10 83138A1
Installation continued
11. Install the pulley mounting bracket (Figure 13).
This bracket must be installed on the right side of
the plow as shown. Remove the two plow base
bolts as shown in Figure 12.
NOTE: The pulley mount contains two L brackets.
The L-bracket with longer leg ts under shorter
L-bracket.
13. Position shorter L-bracket over longer bracket.
Secure the brackets to tube assembly with longer
M10 ange head bolts provided in this kit.
Tighten the fastener at this time so that the bolt
engages the nylon in the lock nut.
14. Install the pulley in the mounting bracket as shown
(Figure 14).
Use the 3/8” retaining pin to secure the pulley in
the mount.
Figure 12
Figure 14
Figure 13