Owners manual

WARN INDUSTRIES PAGE 4 83111A0
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure 2
Figure 3
V. INSTALLATION
1. Remove front cargo box. Use a 1/2” socket and
ratchet to remove the (4) bolts near the center of
the box that secure the box to the frame.
2. Use a Torx T-25 screwdriver to remover (8)
screws securing the front body to the cargo box.
Remove (2) on each side located near the box
latch (Figure 3).
Remove (2) on each side located in wheel well
securing the outer fender to box.
3. Use a 1/2” socket and ratchet to loosen the top
bumper bolts (Figure 4).
Loosen these bolts to allow the front bumper to
rotate slightly but do not remove.
Figure 4