Owners manual

WARN INDUSTRIES PAGE 3 76599A0

WARN® and the WARN logo are trademarks of Warn Industries Inc.

Figure 1

Figure 2

V. INSTALLATION

1. Remove factory bolts shown in Figure 1, using torx

drive.

Note: Factory bolts removed in this step will be

reused.

2. Assemble rock sliders reusing factory bolts that were

removed in step one. See Figures 2 and 3.

Note: Do not tighten bolts at this time.

Figure 3

IV. TORQUE SPECIFICATIONS

1/4 (M6) 8 lb. ft. (10.8 N-m)

5/16 (M8) 17 lb. ft. (12.5 N-m)

3/8 (M10) 30 lb. ft. (40.7 N-m)

7/16 (M12) 50 lb. ft. (67.8 N-m)

1/2 (M14) 75 lb. ft. (101.7 N-m)

Remove