Owners manual

WARN INDUSTRIES PAGE 4 71180A1
©2006 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure 4
INSTALLATION CONT.
Figure 6
3. Place one bolt (Ref. #2) per side, through the
lower bumper slots. Put three washers (Ref.
#1) on each side, between the bumper and the
plastic. Loosely fasten the two bolts.
4. Align the tabs at the top of the bumper with
the rack mounts. If there is a gap between the
rack mount and bumper tab, then place a
washer between the mount and the tab.
Fasten the bumper with the remaining two
flange bolts.
Tighten all four bolts (Ref. #2) to the recom-
mended torque of 17lb. ft. (12.5 N-m).
5. Installation is now complete.
Figure 5
Flange Bolt
Rack Mount
Bumper Tab
(Ref. #1)
(Ref. #2)
PROCEED TO SECTION TITLED “MAIN-
TENANCE/CARE”.