Owners manual
WARN INDUSTRIES 2 65019 Rev C0
PARTS LIST
TOOLS REQUIRED
Ratchet, 1/2” or 13mm, 21mm, and 22mm Socket
21mm and 3/4” Wrench
7/32” and 5/16” Allen Wrench
Torque Wrench
TORQUE SPECIFICATIONS
M14 Bolts 130 lb. ft. (176.3 N-m)
1/ 2” Bolts 75 lb. ft. (101.7 N-m)
3/8” Bolts 30 lb. ft. (40.7 N-m)
5/16” Nuts 17 lb. ft. (23.0 N-m)
1.) INSTALLATION OF SKID PLATE BRACKETS
WARNING
Always support the front axle in a manner to prevent rotation. The best way to do this is via vehicle hoist. Never
remove both M14 bolts from the trailing arms at the same time. Failure to support the axle and/or removing
the bolts at the same time could cause the vehicle to become unstable resulting in property damage, injury or
death.
The skid plate mounts as shown in Figure 1. The brackets holding it to the vehicle will be mounted to the frame
of the vehicle then the skid plated mounted to them. Remove the M14 bolts holding the trailing arms on one at a
time. Using the M14 bolts and washers supplied with the kit loosely mount the skid plate brackets as shown in
Figure 2 and Figure 3. Tighten the driver’s side down. If there is a gap on the passenger side between the
bracket and frame, use one or both of the shims supplied to take up the space.
2.) INSTALLATION OF SKID PLATE
Place the 4 3/8” square nuts in the frame brackets as shown in Figure 4. If the vehicle has carriage bolts already
in the transfer case mount/skid pan, remove these before installing the skid plate. Mount the skid plate as shown
in Figure 1 and Figure 4. Use the 1/2” button head bolt and locking nut on the passenger side of the vehicle.
When installing the 5/16” carriage bolts in the rear make sure to use the 5/16” flat washers on the topside.
Tighten to torque specifications listed above.
PART NO. QUANTITY DESCRIPTION
1145 2 1/2” Flat Washer
1324 2 5/16” Flat Washer
1829 4 3/8” Lock Washer
2002 2 5/16-18 Nylock Nut
7355 2 5/16-18 x 1” Carriage Bolt
13697 4 3/8-16 Square Nut
29060 1 1/2-13 Nylock Nut
29136 4 Button Head Bolt, 3/8-16 x 1”
60592 1 Button Head Bolt, 1/2-13 x 1-1/2”
64243 2 Hex Head Bolt, M14-2.00 x 110mm
64177/64183 1 Skid Plate (6 or 4 Cylinder)
64181 1 Right Bracket
64242 1 Left Bracket
64244 2 Shim