Product Manual

PAGE 3 63947 A3
Tighten fasteners to 17 ft. lbs. of torque.
3.0ci Mounting
11. Secure rear of mounting plate to ATV frame tab
extensions using 2, 5/16-18 x 1.00 hex head screws,
2 5/16-18 lock nuts and 2, 5/16 flat washer. Attach
winch to mounting plate using 5/16-18 x 1.00 hex
head bolts found in hardware kit with winch.
12. Tighten u-bolts securely at this time to 7 ft. lbs. of
torque.
13. Attach the extension plate to the bottom tab on grab
bar cover (400 Kodiak only). Use the 10-24 x 5\8
button head, flat washers, lock washer and hex nut.
Torque should be 2 ft. lbs.
NOTE: The extension plate does not need to be used
on the 450 Kodiak application.
14. Attach the grab bar cover to the grab bar using the
6M x 1.0 x 25mm hex washer head bolt. Do not
over tighten; just snug the bolt up until the plastic
grab bar tab starts move under the pressure.
15. Lift grab bar and secure into position using the six
upper fasteners removed in step #2. Tighten 10 ft.
lbs. of torque.
16. Tighten two lower grab bar fasteners loosened in
step #3. Tighten to 10 ft. lbs. of torque.
17. Reinstall six skidpan fasteners removed in step #1.
Tighten to 7 ft. lbs. of torque.