Product Manual

PAGE 2 63947 A3
1. Remove the 6 front skid pan bolts, and set aside.
Remove the plastic grab bar cover from the grab bar.
2. Remove the six upper fasteners attaching the front
grab bar, and set aside.
3. Loosen two lower fasteners attaching the front grab
bar (do not remove).
4. Pull front grab bar away from ATV, and allow to
hang forward of the unit.
5. Place winch mount into position inside of the front
grab bar.
6. Place u-bolt spacer into position between the front
winch mount mounting holes, and place u-bolt over
the front grab bar cross bar, through spacer, into
front winch mount slotted holes. Secure using flat
washer, and lock nut. Hand tighten only at this time.
7. Move winch mount to ensure holes in the winch
mount line-up closely with the holes in the grab bar
winch mounting tabs.
NOTE: The mounting location for the 2.5ci and 3.0ci
winch are different, see middle picture at right for
proper mounting location.
2.5ci Mounting
8. Place winch and fairlead plate into position.
NOTE: Tilt motor side slightly to get upper winch
electrical connector under grab bar support bar.
9. Secure using 4, 5/16-18 x 1.00 winch mount bolts
and lock washers.
10. Tighten u-bolts securely at this time to 7 ft. lbs. of
torque.
NOTE: The 5/16-18 bolts and lock washers will be
found in the hardware kit that came with the winch.
2.5ci
Mounting
Location
3.0ci
Mounting
Location