Installation Guide

29
Cut a length of Warmup
waterproof tape to suit and
press into the thinset using a
trowel, removing any air gaps
or creases taking care not to
damage or dislodge the cable.
To waterproof the joints
between membrane runs and
over the cable joints, apply
a /" layer of waterproof
thinset, 4" either side of the
joint, making sure the cavities
of the membrane are fully
filled.
65
NOTE: At the manufactured joint, the termination joint or anywhere
that you have damaged or pierced the membrane, cover the
penetration with a /" layer of thinset and cover with Warmup
waterproof tape.
NOTE: Where joints are required, overlap the tape by 4" bonding the
two lengths together with a layer of thinset.
Waterproong