Installation Guide

3
Thank you for purchasing the Warmup® NADCM-C Loose Heating Cable. This manual contains
IMPORTANT information regarding the safe use and installation of your heating cable. Please
read through the entire manual carefully before you install or use the product.
Double check your measurements and ensure that you have the correct heating cable for
the area you wish to heat. The heating element MUST NOT be installed under appliances or
permanent fixtures such as refrigerators, cabinets, tubs, vanity units etc.
Before you Begin
Product Information
The Warmup heating Cable consists of:
A twin conductor resistance heating cable with a primary insulation of Fluoropolymer with high
dielectric strength and high temperature properties. The conductors are covered by a ground
braid providing additional mechanical strength and a ground path. A final outer jacket of PVC is
given to make it sturdier and provide corrosion protection.
The heating cable is terminated at one end with a 10’ cold lead. The conductor cores and ground
braid are factory joined in a water resistant joint assembly to each supply conductor and ground
conductor of the unheated lead. The heater is terminated at the other end with a smaller water
resistant joint.
The unheated power connection lead (10ft) can be trimmed to your needs or extended using a
suitable UL-approved wire. Always complete cable connections in a junction box. Do not leave
excess wire in the wall. This must be carried out by a qualified electrician in accordance with
local/state laws and guidelines. Inspect the entire heating cable for damage, this includes the
factory made joint and end termination. If any parts are damaged contact the technical helpline.
The Warmup Heating Cable is approved (File No. E303230).
If you are missing any items from the box or believe that you have the incorrect heaters to
cover the area required, please call the helpline for further assistance.