Full Product Manual
Table Of Contents
- 2. Menu Overview
- 3. Introduction
- 4. General Operation
- 5. Ground Fault: (GFCI/EGFPD) 1/2
- 5. Ground Fault: (GFCI/EGFPD) 2/2
- 6. Icons 1/2
- 6. Icons 2/2
- 7. Startup Wizard
- 8. Programed Heating Schedule
- 9. Operating Choices
- 10. Thermostat Setup Menu 
- 10.1 Heating Schedule 1/2 
- 10.1 Heating Schedule 2/2 
- 10.2 Energy Use 
- 10.3. User Settings 
- 10.4 Installer Settings 
- 10.4.1 Adaptive Function 
- 10.4.2 Open Window 
- 10.4.3 Sensor Application 1/2 
- 10.4.3 Sensor Application 2/2 
- 10.4.4 Sensor Type 1/2 
- 10.4.4 Sensor Type 2/2 
- 10.4.5 Floor Sensor Calibration 
- 10.4.6 Room Sensor Calibration 
- 10.4.7 Floor Protection 1/2 
- 10.4.7 Floor Protection 2/2 
- 10.4.8 Factory Reset 
- 10.5. WiFi Settings 1/3 
- 10.5. WiFi Settings 2/3 
- 10.5. WiFi Settings 3/3 
- 10.5 Weather Settings
- 11. Factory Settings
- 12. Troubleshooting 1/5
- 12. Troubleshooting 2/5
- 12. Troubleshooting 3/5
- 12. Troubleshooting 4/5
- 12. Troubleshooting 5/5
PAGE 70
© 2016 OJ Electronics A/S
12. Troubleshooting 2/5
•Acirclecontainingadotisdisplayedintheupperleftcornerofthescreenandthe
following text is displayed:
“Press on the filled circle”.
Pressure has probably been applied to the screen while power was connected or
the thermostat was turned on. Restart the thermostat in the following way to con-
tinue using it:
1. Hold the power/reset button on the right side of the thermostat to switch it o.
2. Press the power/reset button on the right side of the thermostat to turn it back
on.
The thermostat will then boot normally.
•Theooriswarmingup,butmoreslowlythanexpected.
- Floor protection might be set to “Laminate”, which prevents rapid heating of the
floor.
- The heating element might have insucient capacity to heat the floor.
>
<
Contents