Full Product Manual
Table Of Contents
- 2. Menu Overview
- 3. Introduction
- 4. General Operation
- 5. Ground Fault: (GFCI/EGFPD) 1/2
- 5. Ground Fault: (GFCI/EGFPD) 2/2
- 6. Icons 1/2
- 6. Icons 2/2
- 7. Startup Wizard
- 8. Programed Heating Schedule
- 9. Operating Choices
- 10. Thermostat Setup Menu 
- 10.1 Heating Schedule 1/2 
- 10.1 Heating Schedule 2/2 
- 10.2 Energy Use 
- 10.3. User Settings 
- 10.4 Installer Settings 
- 10.4.1 Adaptive Function 
- 10.4.2 Open Window 
- 10.4.3 Sensor Application 1/2 
- 10.4.3 Sensor Application 2/2 
- 10.4.4 Sensor Type 1/2 
- 10.4.4 Sensor Type 2/2 
- 10.4.5 Floor Sensor Calibration 
- 10.4.6 Room Sensor Calibration 
- 10.4.7 Floor Protection 1/2 
- 10.4.7 Floor Protection 2/2 
- 10.4.8 Factory Reset 
- 10.5. WiFi Settings 1/3 
- 10.5. WiFi Settings 2/3 
- 10.5. WiFi Settings 3/3 
- 10.5 Weather Settings
- 11. Factory Settings
- 12. Troubleshooting 1/5
- 12. Troubleshooting 2/5
- 12. Troubleshooting 3/5
- 12. Troubleshooting 4/5
- 12. Troubleshooting 5/5
PAGE 17
© 2016 OJ Electronics A/S
7.6 Setting the Load Measurement
1. Set whether or not the thermostat is to automatically measure the load of the
underfloor heating element (if set to “OFF”, you will later have to set the floor load
manually).
2. Tap the “Arrow Right” button to continue.
This setting can be changed later if a factory reset is performed.
1
2
>
<
Contents