Full Product Manual

© 2012 OJ Electronics A/S
5
© 2012 OJ Electronics A/S © 2012 OJ Electronics A/S
Type UCG/UDG English
Factory setting: 24 hour clock
SETTINGS
TIME
Setting Day
I want to change the day of the week.
To do so, you must:
1 With Active Display (backlight on) press OK to activate the menu.
2 Press the Up or Down buttons until the SETTINGS option flashes.
3 Press the OK button.
4 Press the Up or Down buttons until the DAY option flashes.
The currently selected day of the week will appear in the lower part of
the display.
5 Press the OK button.
6 Press the Up or Down buttons until the required day of the week
flashes.
7 Press the OK button.
8 Follow the Exit Menu procedure to exit the menu.
Please note: Usually, the electrician who installed the thermostat will have
set the correct time and day of the week.
Factory setting: MON
SETTINGS
DAY
MON
FRI
TUE
SAT
WED
SUN
THU
Read Out
I want to know the amount of time (in percent) that the heating
has been turned on within a certain period.
To do so, you must:
1 With Active Display (backlight on) press OK to activate the menu.
2 Press the Up or Down buttons until the SETTINGS option flashes.
3 Press the OK button.
4 Press the Up or Down buttons until the READOUT option flashes.
5 Press the OK button.
6 Press the Up or Down buttons to the select the period of interest:
2 DAYS, 30 DAYS or 365 DAYS. The percentage of time that the
heating has been turned on will then be indicated in the upper part of
the display.
The Readout submenu also contains information about the Software
version and the type of control (Room, Floor, Regulator or Room limit)
selected for the Application. (See Application for more information).
SETTINGS
READOUT
2 DAYS
30 DAYS
365 DAYS
SOFTWARE
APPLICATION
EXIT
Oset Temperature
I want to adjust the difference in temperature between the ther-
mostat and my room thermometer.
To do so, you must:
1 With Active Display (backlight on) press OK to activate the menu.
2 Press the Up or Down buttons until the SETTINGS option flashes.
3 Press the OK button.
4 Press the Up or Down buttons until the OFFSET TEMP option flashes.
5 Press the OK button.
6 Press the Up or Down buttons to set the oset temperature (in steps
of 0.1°).
7 Press the OK button.
8 Follow the Exit Menu procedure to exit the menu.
Oset is used to compensate for any dierence between the thermostat
and the actual room temperature. It is possible to adjust the oset by up
to +/- 10 °C or +/- 18 °F.
If, for example, the thermostat shows 1° too much, the oset should be
set to 1°. The temperature will then be set 1° lower.
SETTINGS
OFFSET TEMP
Application
I want to select the type of temperature control.
To do so, you must:
1 With Active Display (backlight on) press OK to activate the menu.
2 Press the Up or Down buttons until the SETTINGS option flashes.
3 Press the OK button.
4 Press the Up or Down buttons until the APPLICATION option flashes.
5 Press the OK button.