Installation Guide

STEP 5

INSTALLATION GUIDE

For TWS6 Series hardwired towel warmers

Installation Support •(800) 875-5285 • WarmlyYours

STEP 5: Use a tape measure to measure the distance

between the center points of each wall bracket tube;

record the distances between points AB, AC, CD, and

BD. Mounting point C will determine electrical box

location. See Electrical Assembly in following

instructions.

STEP 6: Mark A, B, C, and D according to the data from

Step 5; It is suggested that this product be installed at

least 23.5 inches (59.69 cm) above floor level.

(WARNING: The electrical connection should avoid all

water). This mounting location must comply with all local

building and electrical codes.

Place towel warmer on the box (or a large sheet of paper) and

lay on a flat surface with mounting tubes facing downwards.

Mark the location of the following:

• The electrical collar (hardwired model only)

• The location of the mounting tubes

Use the template as a guide to mark the wall with the correct

locations of the four mounting tubes (A, B, C, and D)

STEP 6

STEP 7: Drill A, B, C, and D holes with an

appropriately sized bit.

STEP 7

STEP 8: Use a hammer to knock plastic

drywall anchor (f) into wall completely.

STEP 8

STEP 9: Insert long screw (i) through

mounting bracket (g), then screw into plastic

drywall anchor (f).

STEP 9

STEP 10: Install the tube (a) onto the bracket (g).

STEP 10

STEP 11: As shown in the picture, install the

set screws (c) into the hole of all the tubes (a

and b) using the allen wrench; fix the tube (a)

onto the mounting bracket (g).

STEP 11

ALTERNATIVE TO STEPS 5 & 6