Full Product Manual

ACCESSORIES
INSTALLATION GUIDE
For TWS4 Series hardwired towel warmers.
Installation Support •[phone] • WarmlyYours
3 PCS
INSTALLATION: (WARNING: The electrical
connection should avoid all water.)
Please refer to all the following steps if the wall
brackets are taken apart from the vertical bars.
Please refer to Steps 5-11 if the wall brackets are
fixed on vertical bars already.
1 PCS
4 PCS
3 PCS
3 PCS
3 PCS
1 PCS
3 PCS
2 PCS
a
c
d
e
i
j
f
g
h
b
STEP 1
a
c
STEP 2
STEP 3
STEP 1: As shown in the picture, insert the short mounting
screw (d) through the tube in the center of the mounting
tube (a).
STEP 2: Use the short mounting screw (d) to fix the
mounting tube (a) to the threaded metal pad on the
vertical bar on the back of the towel warmer.
STEP 3: Screw down the short mounting screw (d) with a
screwdriver. Note that the set screw of the tube (a) should
point towards the floor when the towel warmer is wall mount-
ed. Fix the remaining two mounting tubes (a) to the vertical
bars with threaded metal pads by repeating Step 1-3.
STEP 4: Guide the electrical cord through the electrical
connection mounting tube (b) and use the long mounting
screw (e) to tighten the electrical connection mounting tube
to the vertical bar.
STEP 4