Installation Guide

ACCESSORIES
STEP 1
a
c
STEP 2
STEP 3
INSTALLATION GUIDE
For TWS3 Series hardwired towel warmers.
Installation Support •[phone] • WarmlyYours
ACCESSORIES
INSTALLATION: (WARNING: The electrical
connection should avoid all water.)
Please refer to all the following steps if the wall
brackets are taken apart from the vertical bars.
Please refer to Steps 5-11 if the wall brackets are
fixed on vertical bars already.
STEP 1: As shown in the picture, insert the
short mounting screw (d) through the tube in
the center of the mounting tube (a).
STEP 2: Use the short mounting screw (d) to
fix the mounting tube (a) to the threaded
metal pad on the vertical bar on the back of
the towel warmer.
STEP 3: Screw down the short mounting screw
(d) with a screwdriver. Note that the set screw
of the tube (a) should point towards the floor
when the towel warmer is wall mounted. Fix the
remaining two mounting tubes (a) to the vertical
bars with threaded metal pads by repeating
Step 1-3.
STEP 4: Guide the electrical cord through the
electrical connection mounting tube (b) and
use the long mounting screw (e) to tighten the
electrical connection mounting tube to the
vertical bar.
3 PCS
4 PCS
3 PCS
3 PCS
3 PCS
1 PCS
3 PCS
2 PCS
a
c
d
e
i
j
f
g
h
1 PCS
b
STEP 4