Installation Guide
2
Afxing the Towel Warmer to the Wall
STEP 1
Draw a diagram of the preferred location of the brackets on the Towel Warmer
box to create a template (see Step 2 for template instructions). At least two of
the four brackets must be attached directly to a stud.
The Summit Plug-In model must be installed less than 6 feet (183cm) from a
properly grounded outlet to ensure the plug can reach. Make sure to measure
the distance from where the plug is attached to the towel warmer to the electrical
outlet. Do NOT use an extension cord to make the connection between the
towel warmer plug and outlet.
STEP 2
Create the template:
A. Place Towel Warmer on the box (or a large sheet of paper) and lay on a
at surface with brackets facing downwards.
B. Mark the location of the brackets.
C. Use the template as a guide to mark the wall with the correct locations
of the four brackets, ensuring the following:
• Plug-in model must be installed less than 6 feet (183cm) from properly
grounded outlet.
Do NOT use an extension cord.
• At least two of the brackets are lined up with a wall stud.
• The towel warmer is level.
• Electrical supply wire can enter the Power Leg.
STEP 3
Install the brackets onto the wall. Use the drywall anchors that are supplied for
the brackets that are not being installed into a stud. Refer to pages 3-4 or 6-7
Note: When installing the Towel Warmer to a cement or brick wall, please use
appropriate screw/anchor type. As wall and other materials vary, specic screw
types are not included. For advice on suitable screw/anchor systems, contact
your local specialized dealer.