Installation Guide
1
Thank you for choosing your nely crafted WarmlyYours Towel Warmer.
Now you can add luxury and comfort to your bathroom with the soothing
embrace of a warm towel or bathrobe upon stepping from the shower. The
radiant heat from the Towel Warmer warms your towel.
Included in this document are all necessary installation and operation
instructions. If you encounter any diculties while installing your system,
installation support is available by phone at (800) 875-5285.
SAFETY INFORMATION
This towel warmer has a temperature limiting device. When internal
temperatures reach 167℉ (75°C) , the device will stop warming and will then
cool down. When temperatures decrease to approximately 149℉ (65°C),
the heating circuit will reactivate.
• Towel Warmers are designed to warm towels and bathrobes only and
should not be used for any other purpose.
• Never stand, sit on or hang on the Towel Warmer unit.
• Never allow children to play on or with the Towel Warmer.
• Make sure that the electrical circuit breaker is shut o at the main panel
before wiring or servicing your Towel Warmer.
• The Towel Warmer must be properly grounded.
• All wiring must be in accordance with the National Electrical Code and
should be performed by a licensed professional who is certied to do
electrical wiring.
• Never place your Towel Warmer inside a shower, sauna or steam room.
• Never attempt to warm more than 2 towels on the Towel Warmer at a time.
Overloading the Towel Warmer will cause the unit to become extremely hot
and may result in a burn if touched.
CLEANING INFORMATION
Clean the Towel Warmer with a soft, non-abrasive, damp cloth while warm.
Once the Towel Warmer has cooled, lightly polish with a soft dry cloth. Do
not use abrasive cleaning powders, metal polish or chlorine-based cleaners
on any part of the Towel Warmer.
INSTALLATION
This appliance must be installed in accordance with the instructions in
the manual and the local electric guidelines relating to electrical xtures in
bathrooms. The Towel Warmer must be on a GFCI protected circuit and be
wired by a professional who is certied to do electrical wiring.