Installation Guide
9
Bracket Assembly Instructions (continued)
Step 3
Measure for bracket positions using the template if desired. At least two brackets
must be attached to a stud.
Step 4
Ax brackets A and E to the wall using screw D and drywall anchor C where
necessary.
Repeat Step 4 for the remaining brackets.
Step 5
Loosen the hex-head screws H at the base of each section of legs using the Allen
wrench F provided. Hang towel warmer by aligning and sliding all four sections
of legs over bracket A and E. Partially tighten hex-head screws D at the base of
each section of tubing to hold the towel warmer in place but do NOT fully secure
the fasteners at this time. Verify that bracket E is rotated to allow set screw to
engage to it.
Hardwired Assembly and wiring
Step 1. Cut power cord as shown.
Step 2. Remove cord from hole.
Step 3. Install plastic plug into Power Leg hole.
Step 4. Using the template marking made on the wall, drill hole for power cord, and
sh power supply cord out of the wall. Place ¾ size mounting bracket E on the
wall and make a mark for the mounting hole.
Step 5. Using an 8mm drill bit, drill hole for the mounting bracket.
Step 6. Insert wall anchor into wall, next to the power cord.
Step 7. Use screw to attach ¾ size mounting bracket.
Step 8. Place collar onto Power Leg and feed power supply cord through the Power Leg.
Step 9. While having assistant hold the towel warmer in place, make power
connections. See connection section in this manual.
Step 10. Push connected wires into Power Leg.
Step 11. Push towel warmer onto all 4 mounting brackets.
Step 12. To fasten the towel warmer to the wall, tighten the 2 set screws on the Power
Leg and tighten the single set screw on the 3 other legs.
Step 13. Have a licensed electrician make connections to the GFCI protected. circuit.
Step 14. Remove plastic shipping caps from vertical bars of towel warmer.