Instructions / Assembly
5. SPECIFICATIONS
Item # Model Dimensions Volts Watts Ohms Amps
TW-F10BS-HW Hardwired
W: 3 5/8” (600mm)
H : 32” (811mm)
D: 4 ¾” (121mm)
120 150 95 1.25
TW-F10BS-PL Plug-In
W: 23 5/8” (600mm)
H: 32” (811mm)
D: 4 ¾” (121mm)
120 150 95 1.25
Product Construction - Innity Towel Warmer
The Innity Towel Warmers are constructed from Type 304 stainless steel
and have a brushed nish. The stainless steel tubing is pre-assembled
and tack-welded together for rigidity. The towel warmer is heated by a
cULus Listed wire. The tubing used to hang the towel warmer is also
made of Type 304 stainless steel with a brushed nish. The plug-in model
is equipped with a UL Listed plug with grounding pin attached to a 6-foot
(1.8m) cord.
Connection Method
The plug-in model has a 6-foot cord, which is located on the right side
of the unit. Keep cord location and length in mind and plan accordingly
when determining placement of the towel warmer in the room. The unit
must be plugged into an outlet that is properly grounded. For automatic
control of the plug-in unit, a timer can be used. The Innity hardwired
model is fed electricity into the towel warmer via a section of stainless
steel tubing. The tubing can rotate to facilitate wiring. The tubing has an
outside diameter suitable to secure the rubber O-ring on the electrical
cover plate. The stainless steel tubing projects through the O-ring and
into the front of the 2” x 4” (51mm x 102mm) electrical junction box that
is properly grounded. This box is secured in the wall and, a water resistant
seal is made with the use of the rubber O-ring. Power can then be fed to
the control unit, which may be located anywhere in the room.
Safety Ratings
Innity Towel Warmers are cULus Listed and are suitable for use in US
and Canadian markets. The main electrical line feeding the towel warmer
must incorporate an Appliance Leakage Current Interrupter (ALCI) for
North America.
11