Installation Guide
10
Bracket Assembly Instructions (continued)
Step 3
Measure for bracket positions using the template if desired. At least two brackets
must be attached to a stud.
Step 4
Ax brackets C and H to the wall using screw G and drywall anchor F where
necessary.
Repeat Step 4 for the remaining brackets.
Step 5
Place and orient the legs A and M with the threaded inserts located at four points
on the back of the towel warmer. Ax legs (A and M) to the threaded inserts with
bolt B and tighten using the large Allen wrench i provided.
Repeat Step 5 for the remaining sections of tubing.
Step 6
Loosen the hex-head screws D at the base of each section of legs A using the
smaller Allen wrench L provided. Hang towel warmer by aligning and sliding all four
sections of legs A and M over bracket C and H. Partially tighten hex-head screws
D at the base of each section of tubing A and M to hold the towel warmer in place
but do NOT fully secure the fasteners at this time. Verify that bracket H is rotated to
allow set screw to engage to it.
Hardwired Assembly and wiring
Step 1. Cut power cord as shown.
Step 2. Remove Power Leg.
Step 3. Install plastic plug into Power Leg.
Step 4. Using the template marking made on the wall, drill hole for power cord, and sh
power supply cord out of the wall. Place ¾ size mounting bracket H on the wall
and make a mark for the mounting hole.
Step 5. Using an 8mm drill bit, drill hole for the mounting bracket.
Step 6. Insert wall anchor into wall, next to the power cord.
Step 7. Use screw to attach ¾ size mounting bracket.
Step 8. Place collar onto Power Leg and feed power supply cord through the Power Leg.
Step 9. While having assistant hold the towel warmer in place, make power connections.
See connection section in this manual.
Step 10. Push connected wires into Power Leg.
Step 11. Push towel warmer onto all 4 mounting brackets.
Step 12. To fasten the towel warmer to the wall, tighten the 2 set screws on the Power
Leg and tighten the single set screw on the 3 other legs.
Step 13. Have a licensed electrician make connections to the GFCI protected. circuit.
Step 14. Remove plastic shipping caps from vertical bars of towel warmer.