Operating instructions



Step 11



Ensure the rubber seal is in position and sealed correctly inside the collar.

Refer to . Slide the brushed stainless collar over the tube until

it is touching the face of the O-Ring on the cover plate.



Plug the cord into a properly grounded outlet. Do NOT use an extension

cord to make the connection between the Towel Warmer plug and

outlet.

Step 12

Hold the Towel Warmer in place while tightening the hex-head screws 

at the base of each section of tubing  using the smaller Allen wrench e

provided to secure the Towel Warmer in place.

Step 13

Make sure the unit is turned on using the ON/OFF switch located at the

bottom rail on the left-side (when facing the Towel Warmer). A red light

will illuminate the switch when the switch is turned to the “ON” position.

Refer to Diagram D for switch location.

off

economy

TOWEL WARMER



O-ring

Cover Plate

Towel Warmer

Collar



Hardwired model only

Label

Switch