Operating instructions
Thank you for choosing your nely crafted WarmlyYours Towel Warmer.
Now you can add luxury and comfort to your bathroom with the soothing
embrace of a warm towel or bathrobe upon stepping from the bath or
shower. The radiant heat from the Towel Warmer warms your towel. Included
in this document are all necessary installation and operating instructions.
For model number, reference the location of the product label as shown in
Diagram D on page 7. If you encounter any difculties while installing your
Towel Warmer, installation support is available by phone between the hours
of 8:00am - 5:30pm CST, Monday through Friday by calling (800) 875-5285.
If a return is necessary, please use original packaging.
• Towel Warmers are designed to warm towels and bathrobes only and should not
be used for any other purpose.
• Never stand, sit on or hang on the Towel Warmer unit.
• Never allow children to play on or with the Towel Warmer.
• Make sure that the electrical circuit breaker is shut off at the main panel before
wiring or servicing your Towel Warmer.
• The Towel Warmer must be properly grounded.
• All wiring must be in accordance with the National Electrical Code (NEC)
and Canadian Electrical Code (CEC) and should be performed by a licensed
professional who is certied to do electrical wiring.
• Never place your Towel Warmer inside a shower, sauna or steam room.
• Never attempt to warm more than two (2) towels on the Towel Warmer at a time.
Overloading the Towel Warmer will cause the unit to become extremely hot and
may result in a burn if touched. (See page 10 for additional information.)
• Innity Towel Warmers are cULus listed for use in US and Canadian markets.
• Never use an extension cord (for Plug-in model).
Clean the Towel Warmer with a soft, non-abrasive, damp cloth while warm.
Once the Towel Warmer has cooled, lightly polish with a soft dry cloth. Do
not use abrasive cleaning powders, metal polish or chlorine based cleaners
on any part of the Towel Warmer.
This appliance must be installed in accordance with the instructions in the
manual and the NEC and CEC guidelines relating to electrical xtures in
bathrooms. The Towel Warmer must be on a GFCI protected circuit and be
wired by a professional who is certied to do electrical wiring. If the Towel
Warmer does not heat upon initial installation, PLEASE VERIFY THAT THE
“POWER” SWITCH, LOCATED AT THE BOTTOM OF THE LEFT, VERTICAL
POST, IS IN THE “ON” POSITION.
1