Installation Guide

STEP 2: GATHER TOGETHER REQUIRED INSTALLATION TOOLS

The following materials are required to perform a oor warming system

installation:

1. Digital Ohm Meter

2. Hot Glue Gun, Duct Tape or Staple Gun (for holding the

system in place while working)

3. Broad Tip Permanent Marker and Tape Measure

4. 1/4”, 3/8” or 1/2” Notched Trowel, Depending Upon Tile Size

5. Latex Modied Thinset Cement

STEP 3: ROUGH-IN ELECTRICAL WORK

The National Electric Code (NEC) recommends a dedicated circuit for all

oor warming systems. Local codes may differ, so always consult with a

qualied electrician rst.

When installing a thermostat, use a 4” square,

2 1/8” deep electrical box with a single mud

ring. Electrical boxes are typically placed at

eye level (roughly 5’ off the oor).

Note: A licensed, qualied electrician should

perform the installation of the system thermostat

or control device and nal electrical hook-up.

The installation requires an electrical conduit

and a housing box.