Full Product Manual
Operating Tips
SECTION 7
7.1 Operating Tips
7.1.1 When first energized, the TempZone™ Floor Heating Cables may take approximately 1 to 3 hours or more to
fully warm your floor. Heating results will vary depending on climate and building materials.
7.1.2 Energy consumption will vary depending on user preferences. To reduce energy consumption, set the
thermostat to a lower temperature setting or operate for a shorter duration.
7.1.3 Energy consumption can be minimized by turning the system o when floor heat is not required. However,
additional time will be needed for the floor to warm up when the system is turned on again.
7.1.4 WarmlyYours recommends and oers thermostats with a setback option. This option reduces warm-up time
by setting the system to operate at a lower floor temperature, instead of completely turning it o, during the
setback period(s).
7.1.5 Avoid placing thick mats, rugs, mattresses, and broad-based or box-bottomed furniture on the heated floor,
especially where the floor temperature sensor is located. These objects restrict the transfer of heat away from
the cables and trap heat. This causes the floor beneath the object to become warmer than other areas in the
room. Trapped heat may also cause discoloration or damage to some floor covering materials.
7.1.6 Avoid using mats with rubber or vinyl backing, as the heat may cause them to decompose and stain the floor
covering.
7.1.7 When heating a hardwood floor, the flooring manufacturer may require that the floor be kept at a steady
temperature, without a setback. Please consult the flooring manufacturer for any requirements to radiant
heating.
20