Full Product Manual

Free Design Service • 24/7 Installation Support • No Nonsense™ Warranty •[phone] • www.WarmlyYours.com
SHEATH
CORE
CORE
Black Inner Lead
Yellow (120V)
or Red (240V)
Inner Lead
Copper
Ground Sheath
ON OFF
BLACK
GREEN
RED
Wire Construction
Circuit Check Installation
10061
Rev 1/11
BRAIDED GROUND SHEATH
COLD LEAD
BLACK WIRE
RED 240V
or
YELLOW 120V
Installation and Operation
SECTION 5
5.3 Circuit Check™ Instructions
5.3.1 Install TempZone™ Floor Heating Cable
Install the floor heating cable in accordance with the design layout and instructions provided by WarmlyYours.
5.3.2 Test the Circuit Check™
Before connecting any wires, install the batteries in the device and turn it on and o to test the alarm. After
confirming that the alarm is in good working order, connect the wires as follows:
• Connect black inner conductor core wire to the black terminal
• Connect second inner conductor core wire to the red terminal
There are two ways of doing the next step:
1. Split the ground sheath in two. Connect one half of the ground sheath to the green terminal, turn on the
Circuit Check™, and touch the other half of the ground sheath to one of the inner conductor wires.
2. Install the entire ground into the green terminal. Turn on unit and use a paper clip as a bridge between
the ground wire and either one of the inner conductors.
Either method should activate the alarm. If the Circuit Check™ does not pass all these tests, please call
WarmlyYours 24/7 Installation Support at [phone] for assistance.
5.3.3 Activate the Circuit Check™ and Proceed to Install Flooring
5.3.4 If the Circuit Check™ Alarm Sounds, Stop!
If the alarm sounds, there is a short in the circuit or break in the system. Refer to the troubleshooting guide in
section 8 of this installation manual or call 24/7 Installation Support at [phone].
WarmlyYours can ship a splice kit to repair the short. Alternatively, the wire may be repaired by an electrician.
Please see the wire repair documents “Instructions for Twin Conductor TempZone™ Repair” at www.
warmlyyours.com/publications/TZ-TWIN-REPAIR-30027-B/download and “TempZone™ Cut & Turn Twin
Conductor Solder Method Wire Repair” at
www.warmlyyours.com/publications/TZ-TWIN-SOLDER-REPAIR-30028-A/download or call us 24/7 at (800)
875-5285.
11
Figure 5. How to connect the Circuit Check™ for installation