Installation

Preparation
1. PROTECTIVE EYEGLASSES ARE REQUIRED.
2. Wear gloves and appropriate clothing.
3. Cover surface of the work area and the carpet or ooring under the countertop to protect these areas from drips or spills
of the Surface Prep Coating.
4. On the underside of the counter, use a pencil to mark the general outline of where the heater will be attached. Surface
Prep Coating should be carefully applied to the area, ensuring that the perimeter of the heater will be attached to coated
stone.
5. Do not mix the Surface Prep Coating epoxy directly on the stone. Use the mixing tin provided. The mixing tin with mixed
epoxy may become warm, so set it on a piece of scrap material like cardboard.
IMPORTANT: Once the two tubes of epoxy are mixed together, the coating has a limited work life.
Do not mix the ingredients until just prior to brushing on the coating.
The mixed epoxy will begin to harden in about 3-5 minutes.
IMPORTANT: If you have two kits included with your FeelsWarm mat, mix and apply one kit at a time.
Applying the Coating
1. In the mixing tin, combine the entire contents of the tubes containing both Part A and Part B of the epoxy. Stir together
using the tongue depressor. It is important to thoroughly combine Part A and Part B.
2. Use the enclosed brush to apply a thin layer of the Surface Prep Coating to the underside of the countertop. Start
by applying an inch-wide path (inside the penciled outline) around the entire perimeter of where the heater will be
attached. The coating must cover where the edges of the heater will attach to the countertop. It is not critical to coat
the entire surface where the heating element attaches, but you may do so if there is enough coating available. Focus on
working quickly and not precision. Bristles from the brush may come off, but the heating mat will cover them up.
3. Brush on the coating in thick strokes. The consistency of coating is similar to thick honey. The coating will not drip down
vertically if a thin coat is applied.
4. Complete the application quickly. The coating will start to harden and will no longer be usable within 5 minutes after
mixing the epoxy.
After Application
1. The coating will harden completely in approximately 30 minutes (at 70 degrees F). Avoid touching the coating prior to
that time.
2. Once the surface is no longer tacky, the surface is ready.
3. Wipe the surface with isopropyl alcohol prior to installing the heater.
4. Attach the heating element to the counter following the instructions in this manual.
Customer Support
For questions or support, contact WarmlyYours at [phone] or go to WarmlyYours.com.
Installation Instructions
SECTION 2
4