Full Product Manual

5
CONTROLLING YOUR SYSTEM:
To control the Environ II heaters, WarmlyYours
recommends any of the thermostats from our nSpiration
Series. These thermostats come with a oor sensor that
allows you to set your heater to the exact temperature
you desire. The programmable models (nSpire Touch
WiFi, nSpire Touch, and nHance) even allow you to set
a schedule for the heating system— for example one
may chose to have a warm bedroom carpet rst thing
in the morning upon waking, the carpet does not need
to remain warm during the day, but can be programmed
to come on again for a few hours around bedtime!
Most wood laminate manufacturers specify that their oors should not be
subjected to temperatures in excess of 84 degrees Fahrenheit. The only
reliable way to achieve this is to install a temperature sensor on top of, or
directly under the Environ II panel, placed under the wood laminate.
Check
with your laminate manufacturer or WarmlyYours to see what are their
recommendations for installing electric radiant heat under their oors.
PROFESSIONAL ELECTRIC INSTALLATION:
Caution: Only a qualied person who is familiar with the construction and
operation of the apparatus and the hazards involved shall install this product.
The installation of electrical systems presents risks of re and electrical shock
which can result in personal injury. Caution should always be taken to guard
against each such risk. Only a qualied electrician should connect Environ
II panels to the thermostat and / or to the electrical supply circuit. All such
connections MUST be in accordance with the National Electrical Code and all
local Codes. A carpet layer, ooring contractor or a Do-It-Yourselfer can install
the panels on the oor, before the electrician connects them to a thermostat
and an electrical circuit.
For USA installations: All such connections MUST be in accordance with the
National Electrical Code and all local Codes.
For Canadian installations: The installation shall be made according to the
provisions of Section 12 and 62 of the Canadian Electric Code Part 1 which
reads:
ITEMS REQUIRED FOR SYSTEM INSTALLATION:
System components from WarmlyYours
1. The customized installation Plan (or layout)
2. If multiple mats are to be connected to one control device
they must be wired in parallel
3. Control with an in-oor temperature sensor.
Double Check your Dimensions
Check and verify that your plan has the correct room dimensions. Your
order consists of the exact amount of material required to complete your
project. If the measurements of your space have changed, this will affect
how much product is required and how it will be installed. If you have
any discrepancies or questions call WarmlyYours Customer service at
800 875 5285.
Ground Fault Circuit Interrupter
GFCI or ‘GFCI-breaker indicating its capacity if not incorporated into the
control device you are using. This is a built-in feature of the NSpiration
Series control.
Digital Ohm Meter (multi-meter)
Test the foil mats before, during and after the installation. A digital meter
is strongly recommended because of the precise measurements needed.
Electrical Housing Boxes/Switch Plates
All control devices except a Relay Contactor t into a single gang box.
If a double gang box is used it will need to be tted with a single gang
mud ring. We recommend a double gang box with a single gang mud
ring as it provides more room to place all the wires.
“Rule 2-022 Renovation of Existing Installations: The inspection
department may require such changes as may be necessary to be
made to existing installations where, though hard usage, wear and tear,
or as a result of alterations or extensions, dangerous conditions have
developed.”