Specifications

Page 8
1.4 Baffle Positioning The primary heat exchanger baffles consist of one
heavy baffle stack (4mm thick) at the bottom, 3 lighter baffle stacks (3mm thick) in the middle and 1 baffle plate (3mm thick) at the top. Upon installation or after servicing, ensure the baffles are in the correct order and correctly stacked. To achieve maximum efficiency push the primary heat exchanger baffles in the direction of the arrows as shown. The secondary heat exchanger spring baffles must be fully inserted into the heat exchanger tubes (narrow end first).
The primary heat exchanger baffles consist of two
half-width baffle stacks at the bottom, 3 full-width baffle stacks in the middle and 1 baffle plate at the top. Upon installation or after servicing, ensure the baffles are in the correct order and correctly stacked. To achieve maximum efficiency, push the primary heat exchanger baffles in the direction of the arrows as shown. The secondary heat exchanger spring baffles must be fully inserted into the heat exchanger tubes (narrow end first).
Models up to 120 HE 150 HE Models