Thermostats Quick Start Guide
The Warmboard thermostats are an integral part of the Warmboard Comfort System. It’s very important they are installed correctly to ensure the system operates properly. Follow these simple steps and refer to the complete installation guide for additional information as needed.
Thermostats should be installed after texture and paint. Each thermostat will be snapped into a pre-wired J-Box (at least 18 cu. inches). Once the Warmboard thermostats are powered up, they communicate wirelessly, so now additional wiring is required. 1 Each thermostat is labeled by room. Review the Plan Set to confirm where each thermostat should be installed. It is very important to install each thermostat into the proper location.
Declaration of Conformity 47 CFR § 2.1077 Compliance Information Warmboard Thermostat // FCC ID: 2ASM7-WTS01 Responsible Party – U.S. Contact Information Warmboard Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 USA 877.338.5493 // warmboard.com FCC Compliance Statement This device complies with part 15 of the FCC Rules.
