Warmboard Reset Controller Quick Start Guide
The Warmboard Reset Controller (WRC) receives data from the Manifold Controller(s) and helps distribute and modulate water temperatures based on those needs. The WRC must be installed inside the Warmsource. Follow these steps and refer to the complete installation guide for additional information as needed. Declaration of Conformity 47 CFR § 2.1077 Compliance Information Warmboard Reset Controller // FCC ID: 2ASM7-WRC01 Responsible Party – U.S. Contact Information Warmboard Inc.
The Warmboard Reset Controller (WRC) should be installed into the mounting bracket located in the bottom portion of the Warmsource unit. The Warmsource should already be installed and mounted according to the guidelines provided. 1 Remove the front cover of the Warmsource. 2 Fasten the WRC to the mounting bracket using the screws provided. Connect the power cord from the top half of the unit to the “Boiler” port. Connect the power cables from the Pump(s) to the appropriate port.
Warmboard, Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 1.877.338.5493 warmboard.
