Quick Start Guide

Each MC is labeled with the location where it should be installed. Manifold Controllers

install inside each manifold cabinet and require their own 120V outlet. Typically, they

should be fastened in place above the manifold. Review the Plan Sets to ensure each

manifold cabinet is sized and constructed properly based on our specications prior to

installation of the MC.

Remove the Manifold Controller from the box and make sure the antenna

is rmly attached.

Double check the label and make sure the MC is being installed into the

correct manifold cabinet.

Fasten the MC to the plywood in the manifold cabinet using 4, ½ screws.

Plug in the MC to the power outlet, and adjust the antenna as needed.

Review the Plan Set, then connect the actuators to the proper ports on

the right side of the MC. The color-coded stickers should make this easy.