Manifold Controller Quick Start Guide
The Warmboard Manifold Controller (MC) communicates with the Warmsource and Actuators to control the flow of heat to each zone. Installing the MC involves a minimal amount of labor, but it’s important to pay attention to the details. Follow these simple steps and refer to the complete installation guide for additional information as needed. Declaration of Conformity 47 CFR § 2.1077 Compliance Information Warmboard Manifold Controller // FCC ID: 2ASM7-WMC01 Responsible Party – U.S.
Each MC is labeled with the location where it should be installed. Manifold Controllers install inside each manifold cabinet and require their own 120V outlet. Typically, they should be fastened in place above the manifold. Review the Plan Sets to ensure each manifold cabinet is sized and constructed properly based on our specifications prior to installation of the MC. 1 Remove the Manifold Controller from the box and make sure the antenna is firmly attached.
Warmboard, Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 1.877.338.5493 warmboard.
