Installation Instructions

PULL COLD LEAD AND SENSOR WIRE INTO ECB;

SECURE THE COLD LEAD SPLICE

2.5

z It is important to properly de-coil the cable to prevent twisting. Insert a rod (such as a broom handle) through the cable spool hub

and support on a ladder or equivalent (Figure 6a).

z Pull the Cold Leadfromthespool,andusingshcords,pullitthroughthe¾"holeinthesillplate,upthroughthewallcavityandinto

the ECB. The cable should be pulled until the factory Cold Lead Spliceontheoorisapproximately12"fromthesillplatehole.Allowat

least 6" of cold lead to project from the ECB (Figure 6b).

z Ifyouareusingaoortemperaturecontroller,suchasEasyHeat’sGTS-1orGTS-2,usetheshcordstopulltheSensor Wire through

the¾"sillplatehole,upthewallcavityandintotheECB.Allowatleast6"ofsensorwiretoprojectfromtheECB.RefertoStep2.7

forfasteningthesensorwiretotheoor

z Duetothelargercablediameterofthecoldleadsplice,removeapproximately¼"ofsub-oormaterialwherethesplicewillbe

fastened,toeliminateanypossibleinterferencewiththetile.Forwoodsub-oorsuseautilityknifeorchisel;forconcrete,usean

appropriate masonry chisel (Figure 6c). Remove all debris after this step to avoid cable damage.

z Securethecoldleadspliceandcoldleadtotheoorusing2"lengthsofatRibbonStrapping.Placetheribbondirectlyoversplice

andcoldleadandstapleittotheoor(Figure 6d). ENSURE THAT STAPLES DO NOT PENETRATE THE CABLE!

z Secure any loose Heating Cable between the Start of Runandlocationwhereheatingcableisrstlacedthroughstrapping,usingthe

clips provided or by stapling 2" lengths of the Cable Strappingtotheoor.

Figure

Figure 6a