Specifications

MI 611-211 – October 2005 3. Operation
14
Figure 9. Example of Structure Diagram
Measure
Measure is the normal operating mode of your transmitter. The pH, ORP, or ISE measurement is
shown on the top line of the display. Upon returning to Measure mode after changing many
configuration parameters, the display may read CONFIG ER. This typically means that a
calibration is required.
The second line of your display shows the absolute value of the sensor signal in millivolts, the
output in 4 to 20 mA, or the temperature, depending on your configuration. You can view one of
the other two selections by using the arrow keys. The display will return to the configured
selection when the TIMEOUT time is reached. Transmitter (XMTR ER) and sensor (PROBE ER)
errors are also shown on your display while in the Measurement mode.
CONFIG
TEMP
TEMP
UNITS
UNITS
CELSIUS
UNITS
FAHREN
TEMP
MODE
MODE
AUTO
MODE
MANUAL
DEFAULT
MANUAL
TEMP
TYPE
TYPE
RTD
TYPE
BALCO
RTD
2 WIRE
RTD
3 WIRE
2 WIRE
100 OHM
2 WIRE
1000 OHM
3 WIRE
100 OHM
3 WIRE
1000 OHM