Specifications

7
2. Installation
Unpacking
1. Remove the transmitter from the shipping container and check for visible damage.
2. Save the container until you determine that no shipping damage has occurred.
a. If no damage is observed, proceed to the Mounting procedure.
b. If transmitter has been damaged, notify the carrier immediately and request an
inspection report. Obtain a signed copy of the report from the carrier and contact
the Customer Satisfaction Center at 1-866-746-6477 in the U.S.A., or contact
your local Invensys Foxboro representative.
Mounting
Panel Mounting
Panel mounting of the transmitter is shown in Figure 4. For panel cutout size, space requirements,
and other dimensional data, see DP 611-163.
Figure 4. Panel Mounting
Surface Mounting
Surface mounting of the transmitter is shown in Figure 5. Fasten mounting bracket to transmitter
using screws, washers, and lockwashers provided. Fasten mounting plate to surface using
appropriate hardware. For space requirements and other dimensional data, see DP 611-163.
PA N EL
TRANSMITTER
BRACKET
WASHER
NUT