Hi-Power Blenders MX1000XT, MX1050XT, XT, MX1100XT XT OPERATING MANUAL
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: 1. READ ALL INSTRUCTIONS. 2. To protect against electrical hazards, do not immerse the blender base in water or other liquid. 3. Close supervision is necessary when any appliance is used by or near children or individuals with certain disabilities. 4. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. 5.
GROUNDING INSTRUCTIONS • For your protection, this appliance is equipped with a 3-conductor cord set. • 120 Volt units are supplied with a molded 3-prong grounding-type plug (NEMA 5-15P) and should be used in combination with a properly connected grounding-type outlet as shown in Figure A. If a grounding-type outlet is not available, an adapter, as shown in Figure B, may be used to enable a 2-slot wall outlet to be used with a 3-prong plug.
MX1000XT OPERATION 1. Before starting, make sure that the blender is unplugged. 2. With the unit in Off position, place container on blender base. Be sure container is fully seated and that drive coupling is properly engaged. Plug blender cord into outlet. 3. Put ingredients into container and cover it. Do not fill above MAX line. 4. This blender has 2 speed settings: Hi and Low. Press paddle switch to desired position. To crush ice quickly, use high speed setting. 5.
MX1100XT OPERATION Follow steps 1-3 in the MX1000XT Operation section. 1. This blender is equipped with an electronic membrane keypad. The keypad has a main power On/Off button, plus High, Low, Stop and Pulse buttons and a 30-second countdown timer with Up and Down arrows to set time. 2. Press the On/Off button to turn on the blender. Green LED will illuminate. The electronic timer will indicate 10 seconds (default). Press the Up or Down arrow to set the desired time.
IMPORTANT – HOT BLENDING INSTRUCTIONS To minimize the possibility of being scalded when blending hot materials, the following precautions and procedure must be observed. • Hot materials are those which are 100°F (38°C) or hotter. • Limit the amount of materials processed to 1 pint. • Completely remove the center portion of the two-piece container lid before starting motor (this will allow venting of the rapidly heated and expanding air inside the container when blender is running).
IMPORTANT NOTE: IN ORDER TO MINIMIZE POSSIBILITY OF SCALDING, TEMPERATURE OF WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 115˚F (46˚C), AND QUANTITY USED MUST NOT EXCEED ONE-QUARTER CONTAINER FULL. IF HIGHER TEMPERATURES OR LARGER QUANTITIES ARE USED, OBSERVE ALL PRECAUTIONS GIVEN IN THE OPERATING MANUAL UNDER “HOT BLENDING INSTRUCTIONS”, page 6. 1. 2. 3. 4. TO SANITIZE AND DRY CONTAINER Wipe down exterior of container with a soft cloth or sponge dampened with sanitizing solution.
been sterilized, both by a tag on the item itself and by a statement in the accompanying correspondence. Waring will not accept delivery of any return unless it is so identified. Replacement parts for your out of warranty repairs are obtainable at the below address.
