User guide

DISASSEMBLING
Important: Juice extractor should be unplugged from
outlet when disassembling.
• Afterremovingyournewjuiceextractorfromthebox,
you may want to familiarize yourself with the parts
by disassembling the unit and washing the top parts
(pusher, cover, clutch, cutter blade, strainer basket,
and juice collector bowl, see Figure 1).
• Withjuiceextractorfacingyou(spoutfront),putyour
hands on both sides of the cover. Using the side
arms for leverage, push back with your left hand
and pull forward with your right, turning the cover
clockwise. This will disengage the cover from the
spring clips and disengage the lid safety interlock.
• Lookintojuiceextractorandremoveclutchby
unscrewing counterclockwise.
• Liftoutcutterblade.
• Liftoutstrainerbasket.
• Liftoffbowl.
ASSEMBLING
• Placebowlonmotorbasehousingandplacethespout
facing front between the two raised projections on the
motor base housing.
• Placestrainerbasketinsidethebowloverthehex
drive. Be certain the strainer basket sits flat.
• Placecutterbladeinsidestrainerbasketwithteethup.
• Tightenclutchfingeruntilitistightorsnug.
• Ifusingdisposablefilter,insertitflatagainsttheholes
around the inside of the strainer basket. Once the juice
extractor is running, centrifugal force will push the filter
into perfect position.
• Placecoveronbowlwithfeedchuteattherear,grip
the sides of the lid firmly and turn counter clockwise to
engage the spring clips and the safety interlock.
• IMPORTANTNOTE:Thejuiceextractorwillnotoperate
until the cover is properly assembled to the unit.
3