Instruction Manual

Cable Mount:(purchase seperately)
To suspend the highbay luminaire from cables, slide the button stop attached
to the end of the cable kit through the hole in the end cap. Then, slide the
rectangular plate installed on the cable through the same hole. Attach the
cable to a secure, stationary structure. Use the spring slide to adjust the
height. Choose the appropriate knockout, and wire the fixture in accordance
with proper code.
Surface Mount:(purchase seperately)
To surface mount the highbay luminaire, bolt the fixture brackets to the
ceiling or rail (Figure 1). Once the brackets have been properly secured,
attach the luminaire using the screws provided (Figure 2). Choose the
appropriate knockout, and wire the fixture in accordance with proper code.
Figure 1
Pendant Mount:(purchase seperately)
To pendant mount the highbay luminaire, mount the fixture brackets to
1/2”NPS (Figure 1). Once the brackets have been properly secured
,
attach the fixture using the screws provided (Fixture 2). Choose the
appropriate knockout, and wire the fixture in accordance with proper
code. Secure the cover plates to the bracket using the screws provided.
Figure 1
Figure 2
Motion Sensor/PIR Sensor:(purchase seperately)
To install motion/PIR sensor, first open the driver cover by removing the
screws (Figure 1). Using the knock out on the side cover, mount the
sensor, and make wire connections in accordance with code (Figure 2).
Once the wiring is complete, reattach the driver cover (Figure 3).
Figure 1
Figure 2
Figure 3
Figure 2