Instructions / Assembly

Item #16066
Natural Comforts
36” Rabbit Cage
Assembly
Instructions
Wood Shelf
#901290
Plastic Base
#901294
Wire Cage Set
#901293
Wood Ramp
#901292
Assembly Complete!
Wood Hay Manger
#901278
If you have questions or concerns about this product, contact our
customer service department at 1-800-295-2243 and we will help
you with any problems, Mon-Fri 8:00 – 4:00 MST or email us at
[e-mail]
MADE IN CHINA
to the design specifications of
WARE MFG., INC.
Phoenix, AZ 85009, USA
WWW.WAREPET.COM
#30016066
Revision Date:
4/8/19
Step 5
Attach the hay manger to the wire on one of the short sides
of the cage. Inserting the bottom edge of the manger above
the 2nd wire up from the bottom and positioning so that vertical wire is in
the center of the slot in the manger. The two hooks on the top of the
manger rest on the 7th wire up from the bottom.
Place the assembled wire top with Shelf and Ramp onto the
base making sure the bottom of the wire panels rest securely
along the top edge of the base. Secure the wire panels to the
base using the wire latch located on each side.
Step 3
Slide the Wood Ramp through the hole in the Wood Shelf.
Connect the front cage panel (includes
doorway) to the left side panel as
shown. The “J” shaped wire hooks are
specially designed to hook onto the
side panel alternating the connection
back and forth. Then connect the front
panel and the side panel again to
create a woven connection joint.
Repeat this connection between the
remaining panels in each corner using
the alternating “J” shaped hook.
HINT: Start by attaching bottom “J”
hook and move up and attach top “J”
shaped hook last.
Step 2
Step 1
Place the wire panels on a flat surface with the door facing up. Unfold the
front, back, and side panels.
Then attach the Shelf and Ramp assembly to the 4th wire
up from the bottom on the left side of the cage.
HINT: Attach Wood Shelf and Ramp to the wire cage before
securing wire frame to pan.
Step 4