Quick Installation Instructions for NVR
1. HDD Installation 1. 2. Ensure Power supply has been disconnected, open the case cover; Fx the HDD in the case; 3. Connect HDD data line, power line ; 4. Install the cover.
2. Device Connection After HDD installation,connect the Device as follows: No. Hardware name 1 VGA cable 2 Monitor 3 Outlet 4 Power Adapter 5 IPC 6 Switch 7 Network cable 8 Mouse 3. Login After the Devices connected,Press the power button ,then the NVR booting,Enter the usename and password login the system. The defult username is” admin”,password is “”.
. Connect IPC Devices 1.Right click|System Setup|Net Settin| Connection set the IP of this NVR; 2.
3. Click any ip camera,click button [Add],can put this ip camera into the right device list,and connected successful;Click the button [Add All],can put all ip camera into the right device list,and connected all successful. Unconnect setps: Click any ip camera of the right device list,Click [Remove],can unconnected this connection.Click [Remove All],can unconnect all connection.
5. Remote Connection with CMS Open CMS,in the login interface,select “Device ID Login”,Enter the Device ID,Click Advanced button,Enter the network username and password, Click Login button,then can login successful and connected the NVR Device. 6. Remote Connection with IE Open IE with Http://www.nvsip.
system and connected the NVR Device. 7. Remote Connection with Mobile Phone 1.Download the APP and install it ,after installation,register a user,the login with this user.
2.After Login,Click the button ,Add Device,Enter the Device ID and network username and password. 2.Click [Save] button,then Add this Deviec successful.
3.Click this Device,select one channel,can connect the Device,if you want to see other channels,you can sliding aroud the picture.