Product Specs

SLU-A1000-B
8
is less than 40m (up to 80m in the especially open area)
 No shielding between anchors
 Anchors need to be installed in the front and at the end of
one-dimensional area
If more than two anchors are installed in the one-dimensional positioning
area (for example, the length of the area is more than 40m), the anchor in
the middle is located on the boundary between the two regions and can be
reused by the two regions. As shown in the figure below, the anchor
located in the middle can be shared by Region1 and Region2.
3. Two-dimensional positioning
Two-dimensional positioning is usually used in spaces with an area of
more than 100 square meters, such as large factory areas, large
conference rooms, halls, etc. The positioning area is divided into several
two-dimensional positioning parts. These areas shall meet the following
requirements
 Rectangle, length to width ratio is 1:1, the maximum is not
more than 3:1
 The long side of the rectangle should not be greater than
35m (in open space, the length of the side can be extended to
50m)
 There are no walls, columns, storage shelves, cabinets,
sky-type machinery, etc. The height of the equipment in the
area shall not be greater than 1.5m; if there are above
objects in the rectangular area, the accuracy of
two-dimensional positioning will be reduced and the
distance between anchors will be reduced accordingly.
One-dimensional Positioning
Region1
Region2