Product Specs

SLU-A1000-B
7
4. Anchor selection and
installation
4.1 Anchor selection
To a large extend, the selection of the tag installation location determines
the difficulty of debugging and the final positioning effect, so the
following principles should be referred to during the selection.
1. Zero-dimensional positioning
Zero-dimensional positioning is often used for smaller enclosed areas
with physical boundaries and entrances. For example, a room is often
used as a zero-dimensional area. After leaving the zero-dimensional area,
you can enter the higher dimensional area. For example, after leaving the
room, you can enter the corridor (one-dimensional positioning) or the
office (two-dimensional area).
When the anchor is selected in the zero-dimensional region, the center of
the zero-dimensional region is selected as the location of the anchor
2. One-dimensional positioning
The following conditions should be satisfied when planning the
one-dimensional positioning region.
 The space between each two anchors in the positioning area
Existential Positioning