Product Specs

SLU-A1000-B
12
5. Network Setting Up
In general environment, all anchors in this layer can be networked by
POE switch of the access layer, and then connected to the core layer
switch by means of optical fiber or network server.
Depending on the selected network architecture, each anchor needs a
separate network cable connected to the switch, and the other end is fixed
in a pre-reserved anchor location.
Note:
1. Recommended to use more than five types of network cable
2. Pull the network cable head to the anchor design point, and make a
wire loop with a preset length margin of 1-2m, and place it at the
point.
3. The two ends of the network must be marked with tags in order to find
the two ends of the same network cable
4. The distance from the switch to the anchor should not be more than
90m, if more than 90m, please add a POE switch in the middle to
avoid abnormal power supply of the base station.
5. At this point, the basic engineering installation of the UWB
positioning system is completed, and the next step is the installation
and debugging of the UWB positioning software system.