User's Manual

25
Testing the System
1. Reattach the vehicle’s negative battery cable.
2. Engage the parking brake and turn the ignition key to the ON position. DO NOT
start the vehicle. Put the gear shift into reverse.
3. The camera will start broadcasting, and the GPS unit screen will detect the signal
and enter the Back-up camera mode automatically. The image will be displayed on
the screen and it should match your rear view mirror.
4. When you take the gear shift out of reverse the camera will turn OFF, and the GPS
unit screen will turn back.
After testing the unit and you are satisfied with the route you have chosen for the cabling,
you must permanently install it.
Fully tighten the license plate bolts.
Route all wires behind interior panels or under carpeting so they are hidden.
Use supplied cable ties to neatly gather all excess wire.
Note: Keep camera lens and the GPS unit screen clean to ensure optimum picture
quality.
Operation of the Back-up Camera System
After previous procedure, you can use the Back-up Camera System now.
When driving, put the gear shift into reverse, the GPS unit will detect the signal and
display the image on screen automatically, as shown below.
Note: Keep camera lens and GPS screen clean to ensure optimum picture quality.
Back-up Camera
Installation