User's Manual

24
CAMERA Wiring Diagram
The camera is equipped with Reverse Voltage Protection. If the camera does not operate,
please check that the Red wire is connected to positive (+) and the Black wire is
connected to negative (-).
Scotch-Lok
TM
Instructions
You do not need to use the Scotch- Lok
TM
connectors. The camera can be wired directly
to the reverse light circuit by stripping the reverse light wires then twisting the camera
wires to the exposed reverse light wires. Once connected, wrap with electrical tape. Do
not attempt this if you are not knowledgeable with electrical installation practices.
Back-up Camera
Installation
RED
BLACK
+12V DC REV LAMP
Reverse Lamp
GRUND
The camera’s antenna extends
down the camera’s cable. Do not
cut the camera’s cable shorter
than 41cm or 12”.