User's Manual

5. Some vehicle’s may have a hole available to pass the wire through, you can use an

existing opening (Fig.2) like where a license plate light is mounted, or drill a hole

close to where the power cable is attached to the camera. (Fig.3) Once you have

chosen where the cable will enter the vehicle’s body, remove the camera. If you

able to use an existing opening, skip the next two steps.

6. If you are going to drill a hole, choose a location as close to the camera where the

power cable comes out of it. BEFORE YOU DRILL A HOLE YOU MUST CHECK

AND SEE WHAT IS BEHIND WHERE YOU ARE DRILLING. If there are any

vehicles components, such as electrical parts or fuel system components behind

where you are drilling, you must take whatever precaution is necessary not to

damage them. Remove the license plate and camera before drilling.

7. After you have drilled a hole, insert the supplied wedge (Fig.4), and then pass the

power cable through the wedge into the vehicle (Fig.5). You must use the wedge to

prevent the metal edge of the hole from cutting the power cable.

Back-up Camera

Installation

Fig 2 Fig 3

Fig 4 Fig 5