User's Manual

Back-up Camera System Parts

1. Back Up Camera with Video Cable

2. License Plate Bolts

3. Wedge Shaped Mounting Shims

Note: The parts and supplies included with the camera are sufficient for most

installations. However some installations may require other parts and/or supplies to be

purchase separately.

WARNING: This device, as well as all other wireless devices, may be subject to

interference. Interference may be caused by cell phones, Bluetooth headsets, Wi-FI

routers, power lines and other various electrical equipment, etc. And you could not hold

the GPS unit and mount cradle in your hands because this may results in interference

too.

Camera Installation

You may mount the camera using the license plate’s top or bottom mounting bolts or

screws. When mounting the camera you must make sure that it’s field of view is not

obstructed. Depending on the vehicle, you may mount the camera on the top or bottom

of the license plate. To adjust the angle that the camera is mounted to the vehicle use the

supplied wedge shaped shims.

1. Loosen the license plate bolts/screws, then remove the rear license plate.

2. Insert each license plate bolt into a supplied

wedge, then through the bolt holes of the

camera, then through the remaining wedges

and the license plate. (Fig.1)

3. Align with holes on vehicle and temporarily tighten the license plate bolts/screws.

The wedges will angle the camera down.

4. You will need to choose a route for the camera’s power cable through the vehicle’s

body to the reverse light circuit.

Fig 1

Back-up Camera

Installation

License Plate

edge