User manual

E Troubleshooting , Diagnostics , and Maintenance

------------------------------------------------------------------------------------------------------------------------------------------

--------

USING WANHAO REPLICATORG

-------------------------------------------------------------------------------------------------------------------------------------------

--------------------------------------------------------------------------------

----------------------------------------------------------------------------------------------------

1. Can't load WanHao

Filament into the

extruder

Make a fresh cut at the end of the Filament.

Cut the Filament at an angle—a narrow tip

will help with loading.

PROBLEM

SOLUTION

Use more force when pushing the Filament into

the extruder. Grasp the filament firmly and push it

into the middle of the hole on top of the extruder.

Ensure that you insert the Filament straight down

into the extruder, not diagonally.

After you feel the motor grab the filament,

continue to maintain pressure on the filament for

another five seconds.

2. Object is stuck to

build plate

Wait for the object to cool down. Objects will

detach more easily after they have cooled.

If the object is still stuck, take a thin metal craft

spatula and carefully work the blade under the

edge of the object. When the blade is most of the

way under the object, twist the handle slightly. The

object should come free.

3. Can't remove the

Filament from extruder

Run the filament load script in the onboard Utilities

menu and let the filament advance for about five

seconds. Then run the unload script again.